Abstract:
Несмотря на растущую популярность ионисторов (суперконденсаторов), общепринятая модель разряда и единая методика описания их характеристик пока отсутствуют. Это связано со сложностью физико-химических
процессов, происходящих в них. В данной работе был проведен анализ заряд-разрядных кривых изготовленного в лаборатории и промышленного
ионисторов.
Было показано, что для исследованных ионисторов, в отличие от
обычных конденсаторов, характерен двухступенчатый механизм разряда с
отличающимися примерно на порядок постоянными времени. Быстрый
разряд определяется внутренними параметрами ионистора, а постоянная
времени этого процесса не зависит от сопротивления внешней цепи. Для
медленного процесса постоянная времени линейно зависит от сопротивления внешней цепи, поэтому этот процесс является аналогом разряда обычного конденсатора. Из параметров медленного процесса возможно определить эффективное внутреннее сопротивление ионистора и его емкость.
Соотношение скоростей быстрого и медленного разряда в случаях лабораторного и промышленного ионисторов примерно одинаково, что указывает на сходность процессов, протекающих в них. Существенная разница
между ионисторами наблюдается в соотношении амплитуд напряжений, соответствующих быстрому и медленному процессам. Для промышленного
ионистора вклад напряжения, приходящегося на медленный (зависящий от
параметров внешней цепи) процесс, существенно выше, что говорит о
большей его эффективности при работе в электрических цепях. Despite the growing popularity of supercapacitors (supercondensers), the common model of discharge and the unified method of describing their characteristics are not available as of yet. This is explained by the complexity of the physical and chemical processes occurring there. This work provides an
analysis of the charge/discharge curves for a laboratory-manufactured and an industrial supercapacitor.
It has been shown that a two-step discharge mechanism is typical for the supercapacitors under
study, unlike for usual capacitors, and time constants differ by approximately one order of magnitude.
Fast discharge is determined by the internal parameters of a supercapacitor, and the time constant of this
process does not depend on the external resistance. For a slow process, the time constant is in linear dependence with the external resistance, that is why this process is analogous to the discharge of a usual
capacitor. Using the parameters of the slow process, it is possible to determine the effective internal resistance of the supercapacitor and its capacity.
The ratio of speeds of the fast and slow discharge in case of a laboratory-manufactured and an industrial supercapacitor is approximately equal, what is indicative of the similarity of the processes occurring there. A significant difference between supercapacitors is observed in the ratio of voltage amplitudes corresponding to the fast and slow processes. For an industrial supercapacitor, the contribution of
the voltage of the slow process (which depends on the external circuit parameters) is considerably
higher, what proves its higher efficiency during operation in electric circuits.
Descrizione:
Богданов Евгений Сергеевич – учащийся, МБОУ «Физико-математический лицей № 31
г. Челябинска», г. Челябинск, Российская Федерация.
Сухова Ольга Радиевна – учитель физики, МБОУ «Физико-математический лицей № 31
г. Челябинска», г. Челябинск, Российская Федерация.
Воронцов Александр Геннадьевич – доктор физико-математических наук, доцент, заведующий кафедрой физики наноразмерных систем, Южно-Уральский государственный университет,
г. Челябинск, Российская Федерация, ORCID iD: https://orcid.org/0000-0002-1965-1474,
e-mail: vorontsovag@susu.ru. E.S. Bogdanov, O.R. Sukhova, A.G. Vorontsov
MBOU “Physical-mathematical Lyceum № 31 of Chelyabinsk”, Chelyabinsk, Russian Federation
South Ural State University, Chelyabinsk, Russian Federation
E-mail: vorontsovag@susu.ru